英年早逝的人会有怨气:关于运行tc软件的问题

你的是xp系统吧 TC毕竟是DOS时代的软件 那应该下载一个处理过的TC，但是经过我的使用，所有的TC在winxp上超慢无比，要不然就是经常死机
如果只是学C，不是研究tc的化，建议用DEC++,虽然名字是C++。可是这个也同时很好支持C语言编译器，当然，如果是你们学校要求TC 那还是装98系统再用TC吧
devc++下载http://www2.skycn.com/soft/4639.html

你用记事本打开这个文件:
notepad c:\windows\SYSTEM32\AUTOEXEC.NT

然后看看内容是不是:

@echo off

REM AUTOEXEC.BAT is not used to initialize the MS-DOS environment.
REM AUTOEXEC.NT is used to initialize the MS-DOS environment unless a
REM different startup file is specified in an application's PIF.

REM Install CD ROM extensions
lh %SystemRoot%\system32\mscdexnt.exe

REM Install network redirector (load before dosx.exe)
lh %SystemRoot%\system32\redir

REM Install DPMI support
lh %SystemRoot%\system32\dosx

REM The following line enables Sound Blaster 2.0 support on NTVDM.
REM The command for setting the BLASTER environment is as follows:
REM SET BLASTER=A220 I5 D1 P330
REM where:
REM A specifies the sound blaster's base I/O port
REM I specifies the interrupt request line
REM D specifies the 8-bit DMA channel
REM P specifies the MPU-401 base I/O port
REM T specifies the type of sound blaster card
REM 1 - Sound Blaster 1.5
REM 2 - Sound Blaster Pro I
REM 3 - Sound Blaster 2.0
REM 4 - Sound Blaster Pro II
REM 6 - SOund Blaster 16/AWE 32/32/64
REM
REM The default value is A220 I5 D1 T3 and P330. If any of the switches is
REM left unspecified, the default value will be used. (NOTE, since all the
REM ports are virtualized, the information provided here does not have to
REM match the real hardware setting.) NTVDM supports Sound Blaster 2.0 only.
REM The T switch must be set to 3, if specified.
SET BLASTER=A220 I5 D1 P330 T3

REM To disable the sound blaster 2.0 support on NTVDM, specify an invalid
REM SB base I/O port address. For example:
REM SET BLASTER=A0

去下个MyTC吧 这个在WINXP下很好用 而且是在TC的基础上改的确